Athens Roof Pros provides professional chimney flashing in Athens, GA for residential and commercial properties across Northeast Georgia. A chimney under an Athens canopy stays damp. Brick and mortar hold water, moss grows on the shaded face, and the flashing joint on the low side collects everything the roof sheds from above it, then keeps that pile wet between rains.
The low side is where we find the damage nearly every time. Leaf litter and pine straw dam against the back of the stack, water sits against the shingle course rather than passing cleanly around it, and the deck under that corner goes soft years before anything else on the same roof shows any sign of a problem at all. We open that corner and check the sheathing before quoting any chimney repair.
Any chimney wider than about thirty inches needs a cricket, and a surprising number of Athens chimneys were built without one. Ours are framed as a proper saddle and clad in metal rather than shingled flat across the top, because a shingled cricket carrying a debris load holds exactly the water it was built to shed away. The cricket also gives debris somewhere to go instead of somewhere to sit.
Flashing gets done in two separate pieces, the way it should be. Step flashing woven into each individual shingle course, then counterflashing set into a reglet cut in the mortar joint and sealed with polyurethane, rather than surface-mounted and caulked against the face of the brick. We do not reuse old flashing on a reroof, ever. The reglet is cut cleanly, not chased with a grinder across the brick faces.
Sometimes the roof is not the problem at all. Spalled brick, an open or cracked crown, or a missing rain cap will send water down inside the stack and stain a ceiling in a way that no flashing repair anywhere on the exterior will stop, and when that is what we find we say so and refer it to a mason. We would rather hand off the masonry than sell a flashing job that cannot hold.
On prefabricated chimneys the chase cover is the usual failure point. Galvanized covers rust through from the inside out and pond water in the middle where nobody can see it. We replace them in stainless with a cross break for drainage, a proper drip edge at the perimeter, and a collar sized to the flue rather than caulked to fit. A chase does not need a cricket, but it does need a cover with fall.
Our licensed and insured team brings the right materials and equipment to every job — algae-resistant laminate shingles, copper-clad ceramic granules, zinc ridge strips, self-adhered valley membrane, synthetic underlayment, standing seam 24-gauge steel — and backs the work with a written workmanship warranty. We serve Athens and nearby communities including Watkinsville, Bogart, Winterville, Bishop.
What We Handle
Everything our chimney flashing in Athens covers
One crew, one point of contact, and the full range of chimney flashing work in Athens, GA. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair Athens
- step flashing chimney
- counterflashing reglet
- chimney cricket install
- chimney leak repair
- chase cover replacement
- chimney crown repair
- masonry chimney flashing
- chimney saddle
- roof to chimney joint
- chimney rebuild flashing
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Athens services.
Materials, equipment and how we do chimney flashing
The difference between chimney flashing that lasts and chimney flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with algae-resistant laminate shingles, copper-clad ceramic granules, zinc ridge strips, self-adhered valley membrane, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Athens job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in Northeast Georgia means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney flashing outside Athens
Athens Roof Pros covers Athens and the surrounding communities of Northeast Georgia. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney Flashing in Watkinsville, GA — Oconee County, population 2,896
- Chimney Flashing in Bogart, GA — Oconee County, population 1,326
- Chimney Flashing in Winterville, GA — Clarke County, population 1,201
- Chimney Flashing in Bishop, GA — Oconee County, population 332
- Chimney Flashing in North High Shoals, GA — Oconee County, population 552
- Chimney Flashing in Winder, GA — Barrow County, population 18,338
Start on the Athens Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Athens Chooses Athens Roof Pros
- ✓We read black streaking before we quote, and we say when a roof needs cleaning rather than replacing
- ✓Algae-resistant laminate with copper-clad granules specified on every shingle replacement
- ✓Zinc or copper ridge strips fitted on roofs standing under a closed canopy
- ✓Six-nail patterns and hand-sealed tabs on shaded slopes where sealant strips bond slowly
The standards behind chimney flashing
Quality here is not a matter of opinion — it is written down. The chimney flashing work we do in Athens follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney flashing project in Athens gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney flashing free estimate in Athens, or request a quote and we'll get right back to you.